Filter
Top Products
Page 24 Installation and Use LINDY CPU Switch USB
the command key before a new hotkey command is accepted by the LINDY CPU
Switch USB. HOTKEYs + TAB is an exception and this allows you to ’tab through’
the ports by holding down the hotkeys and repeatedly pressing TAB.
The hotkey command are summarised below (note that the numbers on the numeric
keypad do not form part of a valid hotkey) :
‘HOTKEYs’ and ‘1’ - selects channel 1
‘HOTKEYs’ and ‘2’ - selects channel 2
‘HOTKEYs’ and ‘3’ - selects channel 3
‘HOTKEYs’ and ‘4’ - selects channel 4
‘HOTKEYs’ and ‘TAB’ - selects the next channel. The next channel may be the next
active channel or the next channel in numerical sequence depending upon the
position of option switch 8 (see section 2.4.3).
‘HOTKEYs’ and ‘A’ - selects autoscan mode where each channel’s video is
displayed for the selected time (see section 2.4.2). To cancel autoscan mode simply
select any fixed channel either by hotkey or by using the front panel button.
‘HOTKEYs’ and ‘0’ – switches off the video signal and displays 0. This will cause
some monitors to go into standby mode or switch off. The video signal can be re-
enabled by selecting a channel.
Examples of common hotkey sequences (assuming CTRL + ALT hotkey option):
To select channel 2:
Press
ED
release
ED
To 'tab through' channels:
Press
ED Y
release
Y
press
Y
release
Y
press
Y
release
YED