EtherFast Cable/DSL Router
17
Instant Broadband Series
16
• Default Gateway Address Your ISP will provide you with the Gateway IP
Address. If set to Obtain an IP address automatically, these values are
assigned by your ISP.
• DNS (Domain Name Server) IP Address Your ISP will provide you with
at least one DNS IP Address. If set to Obtain an IP address automatically,
these values are assigned by your ISP.
You can test and see if the above settings are correct by successfully connect-
ing to the Internet.
• PPPoE (Point-to-Point Protocol over Ethernet) Some DSL-based ISPs
use PPPoE to establish communications with an end-user. If you are con-
nected to the Internet through a DSL line, check with your ISP to see if
they use PPPoE. If they do, you will have Enable it. To enable PPPoE:
1. Choose the Enable option within the PPPoE area of the Setup screen.
2. Enter the User Name you use to log onto your Internet connection.
3. Enter your corresponding Password.
• MAC Address Cloning Click on "MAC Address" (next to WAN IP
Address) to display your Router's MAC address, which is a 12-digit code
assigned to a unique piece of hardware for identification, like a social
security number. Some ISPs require that you register the MAC address of
your network card/adapter, which was connected to your cable or DSL
modem during installation. If your ISPs require MAC address registra-
tion, find your adapter's MAC address by doing the following:
Enter those 12 digits into the fields below, and click Apply. This “clones”
your network adapter’s MAC address onto your Router, and prevents you
from having to call your ISP to change the registered MAC address to the
Router’s MAC address.
Setup
The Basic Setup screen is the first screen you will see when you access the Utility.
If you have already installed and setup the Router, you have already seen this
screen and have already properly configured all of the screen’s values.
• Router Name This entry is necessary for some ISPs.
• Domain Name This entry is necessary for some ISPs.
• Firmware Version This entry shows the version of the firmware you are
using. Future versions of the Router’s Firmware may become available on the
Linksys Website.
• LAN IP Address and Subnet Mask The IP Address and Subnet Mask of the
Router as it is seen on the internal LAN. The default value is 192.168.1.1 for
IP and 255.255.255.0 for Subnet Mask.
• WAN IP Address and Subnet Mask The IP Address and Subnet Mask of the
Router as seen by external users on the Internet (including your ISP). If set to
Obtain an IP address automatically, these values are assigned by your ISP.
NNoottee::
The Setup
page shown in the
graphic below may
differ from the one
seen on your router.
NNoottee::
This is a
sample screen.
Please enter
the MAC
Address for
your Network
Card/Adapter
into this field.