Filter
Top Products
29
Chapter 6: Configuring the Wireless-G Music Bridge
The Status Tab
Wireless-G Music Bridge
not be enabled. The Bridge sends Request to Send (RTS) frames to a particular receiving station and negotiates
the sending of a data frame. After receiving an RTS, the wireless station responds with a Clear to Send (CTS)
frame to acknowledge the right to begin transmission. The RTS Threshold value should remain at its default value
of 2347.
Change these settings as described here and click the Apply button to apply your changes or Cancel to cancel
your changes. Click the Help button if you need more information.
The Status Tab
The Status Tab displays your Bridge’s current status and its settings.
The Firmware, Regulatory Domain, Device Name. The local network’s MAC Address, Configuration Type, IP
Address, Subnet Mask, Default Gateway, will be displayed. The wireless network’s MAC Address, SSID, Wireless
Mode, Channel, Network Mode, and Security will be displayed.
Firmware. The Bridge’s current firmware version is displayed here.
Regulatory Domain. The regulatory’s domain is displayed here.
Device Name. This is the specific name for the Bridge that you set on the Setup Tab.
LAN
MAC Address. This is the Bridge’s LAN MAC Address.
Configuration Type. This shows the network configuration type used by the Bridge.
IP Address. This shows the Bridge’s IP Address, as it appears on your local, Ethernet network.
Subnet Mask. This shows the Bridge’s Subnet Mask.
Default Gateway. This shows the Bridge’s Default Gateway.
Wireless
MAC Address. This is the Bridge’s wireless MAC Address.
Wireless Network Name (SSID). This is the wireless network that the Bridge connects to.
Figure 6-9: Status