Filter
Top Products
11
Setting Up: Basics
Linksys WAP300N
4.
Configure the following fields:
Wireless Band—Select the 2.4 GHz or 5 GHz radio band. The 5GHz band
is much less crowded than the 2.4 GHz band, so it is more likely to be
free from interference. Although the 5 GHz band is ideal for streaming
multimedia, not all wireless client devices support the 5GHz radio band.
Network Mode (5 GHz)—Select your network’s wireless standard. If you
have both Wireless-N (802.11n) and Wireless-A (802.11a) devices in your
network, keep the default setting, Mixed. If you have only Wireless-N
devices in your network, select Wireless-N Only. If you have only
Wireless-A devices in your network, select Wireless-A Only.
Network Mode (2.4 GHz)—Select your network’s wireless standard.
If you have Wireless-N (802.11n), Wireless-G (802.11g), and Wireless-B
(802.11b) devices in your network, keep the default, Mixed. If you
have only Wireless-N devices, select Wireless-N Only. If you have only
Wireless-G and Wireless-B devices in your network, select Wireless-B/G
Only. If you have only Wireless-G devices, select Wireless-G Only. If you
have only Wireless-B devices, select Wireless-B Only.
Network Name (SSID)—The SSID is the name of your wireless network.
This network name is shared among all the wireless devices connected
to your wireless network. The SSID is case-sensitive.
Channel Width—For best performance in a Wireless-N network, select
40MHz only (available only in the 5GHz radio band) or Auto. In Auto
mode, the WAP300N and the network client devices automatically switch
to the 40 MHz mode if:
• Your wireless client devices support the 40 MHz mode in which two
20MHz channels are bonded together for better performance.
and
• There is no adjacent interference.
Channel—Select the operating channel for your wireless network. Your
WAP300N will automatically select the channel with the least amount
of interference if you leave the default Auto setting. We recommend
keeping the default (Auto).
SSID Broadcast—Select Enabled (default) to allow wireless client
devices to “see” the wireless network name. If you do not want to
broadcast the WAP300N’s SSID, select Disabled. We recommend keeping
the default setting (Enabled).
5.
Click Save Settings.
How to set up wireless security
To set up wireless security for your WAP300N in Access Point mode:
Wireless > Wireless Security
1.
Log into the browser-based utility (see “How to open the browser-based
utility” on page8).
2.
Click the Wireless tab, then click the Wireless Security page and select
the Security Mode. (We recommend WPA2 Personal for most home
networks.)
Depending on the security mode you selected, you may be asked to
enter additional information (see the following table).
Security mode
Information
Required Description
WPA2/WPA
Mixed Mode,
WPA2 Personal,
WPA Personal
Passphrase
Enter the passphrase of 8-63 characters.
WPA2/WPA
Enterprise
Mixed
Mode, WPA2
Enterprise,
WPA Enterprise
RADIUS Server Enter the IP address of the RADIUS server.
RADIUS Port
Enter the port number of the RADIUS
server. The default is 1812.
Shared Key
Enter the key shared between the router
and the server.
WEP
Encryption
Select a level of WEP encryption, 40/64-
bit (10 hex digits) or 104/128-bit (26 hex
digits).
Key 1
Enter the WEP key of your network. Key
1 is the transmit key used by this device.