Filter
Top Products
8
Quick Configuration Overview
Wireless-G Business Ethernet Bridge
Chapter 5
Switch
You use the Switch tabs to enter settings that are used by
the Bridge’s switching features.
Port Management Use this screen to configure the
Administrative Status, Flow Control, Link, Duplex, and
Speed of the Bridge’s ports.
Port Mirroring Configure Port MIrroring on this screen.
VLAN This screen lets you configure Port-Based or 802.1Q
VLAN settings.
MAC Based ACL Use this screen to create a MAC-based
Access List (ACL) to control which MAC addresses can
access your network.
QoS On this screen you configure the Quality of Service
(QoS) settings on the Bridge’s ports.
Spanning Tree This screen is used to configure the
Spanning Tree Protocol settings on the Bridge.
MAC Table Use this screen to configure the Bridge’s MAC
address table settings.
Administration
You use the Administration tabs to manage the Bridge.
Password Use this screen to change the password.
SNMP This screen is used to enter the Simple Network
Management Protocol (SNMP) settings.
Config Management Use this screen to save the Bridge’s
configuration to a file, and to restore the configuration
from a file.
Factory Default Use this screen to reset the Bridge to its
factory default settings.
Firmware Upgrade Upgrade the Bridge’s firmware on
this screen.
System Status
The System Status tab lets you view status information
for your local network, wireless networks, and network
performance.
System Status This screen displays basic system
information, including system up time, firmware version,
MAC address, and LAN settings.
Wireless Status This screen displays wireless network
settings including SSID, network type, wireless mode and
channel, security mode, transmit rate, and link quality.
Port Statistics This screen displays the current traffic
statistics of the Bridge’s Wireless and LAN ports.