Filter
Top Products
Chapter 6
Advanced Configuration
19
Wireless-G Business Ethernet Bridge
Web HTTPS Access If you want to enable https access,
select Enabled. The default setting is Disabled.
Click Apply to apply your changes, or click Cancel to
cancel your changes.
Administration > SNMP
This screen is used to configure Simple Network
Management Protocol (SNMP), a popular network
monitoring and management protocol.
Administration > SNMP
SNMP To disable SNMP, leave Disabled selected (default) .
To enable SNMP, select Enabled, then select the type of
SNMP to use, either SNMP V1 & V2 or SNMP V3.
Device Name Enter the name of the Wireless Bridge.
Contact Enter the contact information for the Bridge.
Location Enter the location of the Wireless Bridge.
SNMP V.3 Username Enter the username for the SNMP
V3 administrator who will access and manage the MIB
objects.
Authentication Password Enter the authentication
password for the SNMP V3 administrator. The password
must be at least 8 characters in length.
Privacy Password Enter the privacy password for the
SNMP V3 administrator. The password must be at least 8
characters in length.
Get Community Enter the name of your Get community.
Set Community Enter the name of your Set community.
SNMP Trap-Community Enter the name of your Trap
community.
SNMP-Trusted Host Enter the IP address of your Trusted
host. To have the Access Point respond to SNMP messages
from every host in your LAN, enter 0.0.0.0.
SNMP Trap-Destination Enter the destination IP address
for traps. To prevent traps from being sent to any of your
LAN hosts, enter 0.0.0.0.
Administration > Configuration Management
Administration > Configuration Management
This screen lets you save the system configuration to
a file as well as restore the system configuration from a
previously saved file.
To save the configuration, click Save Configuration
To File, then follow the prompts to save the file to your
computer.
To restore the configuration from a file, enter the name of
the file or click Browse to locate it, then click Apply.
Administration > Factory Defaults
This screen is used to restore the Bridge’s factory default
settings. When you do this, you will lose all previously
configured settings and cannot recover that configuration
unless you have saved it using the Configuration
Management screen.
Administration > Factory Defaults
Select Yes next to Restore Factory Defaults, then click
Apply to restore the defaults and restart the Bridge.