Filter
Top Products
15
Chapter 5: Configuring the Wireless-N Gigabit Gaming Router
The SETUP Tab - BASIC SETUP - PPPoE
Wireless-N Gigabit Gaming Router
The SETUP Tab - BASIC SETUP - PPPoE
Internet Connection Type
Some DSL-based ISPs use PPPoE (Point-to-Point Protocol over Ethernet) to establish Internet connections for
end-users. If you use a DSL line, check with your ISP to see if they use PPPoE. If they do, you will have to enable
it.
User Name and Password. Enter the User Name and Password provided by your ISP.
Service Name. If provided by your ISP, enter the Service Name.
Connect on Demand and Max Idle Time. You can configure the Router to cut the Internet connection after it has
been inactive for a specific period of time (Max Idle Time). If your Internet connection has been terminated due to
inactivity, Connect on Demand enables the Router to automatically re-establish your connection as soon as you
attempt to access the Internet again. To use Connect on Demand, click the radio button. If you want your Internet
connection to remain on at all times, enter 0 in the Max Idle Time field. Otherwise, enter the number of minutes
you want to have elapsed before your Internet access disconnects.
Keep Alive and Redial Period. This option keeps your Internet access connected indefinitely, even when it sits
idle. If you select this option, the Router will periodically check your Internet connection. If the connection is
down, then the Router will automatically re-establish the connection. To use this option, click the radio button
next to Keep Alive. The default Redial Period is 30 seconds.
Network Address Server Settings (DHCP)
DHCP Server. The Router can be used as a Dynamic Host Configuration Protocol (DHCP) server for your network.
A DHCP server automatically assigns an IP address to each computer on your network. Unless you already have
one, it is highly recommended that you leave the Router enabled as a DHCP server.DHCP is enabled by factory
default. If you already have a DHCP server on your network, set the Router’s DHCP option to Disable.
Starting IP Address. Enter a value for the DHCP server to start with when issuing IP addresses. Because the
default IP address for the Router is 192.168.1.1, the Start IP Address must be 192.168.1. 2 or greater, but smaller
than 192.168.1.254. The default Start IP Address is 192.168.1.100.
Maximum Number of DHCP Users (Optional). Enter the maximum number of PCs that you want the DHCP server
to assign IP addresses to. This number cannot be greater than 253. The default is 50.
Client Lease Time. The Client Lease Time is the amount of time a network user will be allowed connection to the
Router with their current dynamic IP address. Enter the amount of time, in minutes, that the user will be “leased”
Figure 5-4: SEUP: BASIC SETUP: PPoE Settings