Filter
Top Products
MAGMA
10 Chapter 2 Hardware Installation
CAUTION
If you are using a power source other than 110V US Standard, you
will need a different power cord to connect your source power to the
power adapter, or a power cord adapter so you can plug the 110V
US Standard power cord directly into your source power.
Fortunately, the power supply is auto-switching, so the only thing you
will need is the correct power cord connector.
Applying Power Correctly
You must apply power to Magma ExpressBox
1
BEFORE you power up
your computer. This allows the computer BIOS to identify and assign
resources appropriately.
Check the front of the enclosure to be sure there is a glowing red LED in
a ‘steady state’. If the LED is flickering turn power off and on until a
‘steady state’ is reached.
IMPORTANT
When powering up, pay close attention to LEDs on that
shines through the front panel. The red light must be solid
red
before the system will function properly. If the red LED is
flickering, there may be a power problem occurring during
start-up. This problem may be resolved by turning
ExpressBox off and on again until the LED remains on at a
steady state.