Filter
Top Products
31
Information
Ⅵ PLE
AUTO ..............The brightness of the screen is
adjusted automatically to suit the
picture quality.
LOCK .............. The brightness level is set to
minimum.
Ⅵ ORBITER
OFF .................Orbiter mode does not function.
ON ...................The picture moves around the screen
intermittently.
Ⅵ INVERSE
OFF .................Inverse mode does not function.
ON ..................... The picture is displayed alternately
between positive image and negative
image.
You can set the time by pressing the
PROCEED button while “ON” is set.
WT .................. The entire screen turns white.
You can set the time by pressing the
PROCEED button while “ON” is set.
Ⅵ SCREEN WIPER
OFF .................Screen wiper mode does not function.
ON ...................Repeatedly moves the white vertical
bar from the left end of the screen to
the right end at a constant speed.
You can set the time by pressing the
PROCEED button while “ON” is set.
Ⅵ Restoring the factory default settings
Select “RESET” from the function menu. Note that this
also restores other settings to the factory defaults.
* Only the PLE and ORBITER can be adjusted when a
RGB signal is connected.
Setting the time for “INVERSE”
Set the “INVERSE” or “WHITE” display time and the
“WAITING TIME”.
Example: Setting so that the INVERSE mode starts
in 30 minutes and proceeds for one and a half hours.
Perform Steps 1-2 on Page 30, then
3. Use the ▲ and ▼ buttons to select “INVERSE”, then
use the
ᮤ
and
ᮣ
buttons to select “ON”.
LONG LIFE
: AUTO
: OFF
: ON
: OFF
RETURN
EXIT
PLE
ORBITER
INVERSE
SCREEN WIPER
SEL.
OK
PROCEED
4. Press the PROCEED button.
The “INVERSE/WT” screen appears.
INVERSE/WT
: ON
SEL. ADJ. RETURN
EXIT
WORKING TIME
5. Adjust the time using the
ᮤ
and
ᮣ
buttons and the ▲
and ▼ buttons.
The mode switches as follows each time the
ᮤ
or
ᮣ
button is pressed.
INVERSE/WT
: 1H
: 30M
: 0H
: 30M
SEL. ADJ. RETURN
EXIT
WORKING TIME
WAITING TIME
The 1st line of the “WORKING TIME”:
→
ON or 0H ↔ 1H ↔ 2H ↔ 3H ↔ ... ↔ 12H ←
* The “WORKING TIME” (minutes) and “WAITING
TIME” cannot be set when the “WORKING TIME”
is “ON”.
5. Once the setting is completed...
Press the EXIT button to return to the FUNCTION
menu.
To exit the main menu, press the EXIT button twice.