Filter
Top Products
Marathon Monitors Inc.
AACC 2000 Carbon Nov. 1, 1997
92
Calibration points and Calibration offsets
If you wish to see the points at which the User calibration was performed and the
value of the offsets introduced, then these are shown in Configuration, in ‘CAL-
Conf’.
The parameters are:
Name Parameter description Meaning
pt1.L
Low calibration point for Input 1 The factory calibration point at which the
low point offset was performed.
pt1.H
High calibration point for Input 1 The factory calibration point at which the
high point offset was performed.
OF1.L
Offset Low for Input 1 Calculated offset, in display units.
OF1.H
Offset High for Input 1 Calculated offset, in display units.
pt2.L
Low calibration point for Input 2 The factory calibration point at which the
low point offset was performed.
pt2.H
High calibration point for Input 2 The factory calibration point at which the
high point offset was performed.
OF2.L
Offset Low for Input 2 Calculated offset, in display units.
OF2.H
Offset High for Input 2 Calculated offset, in display units.
Note: The value of each of the parameters in the above table may
also be altered by using the /
buttons.