Filter
Top Products
HSDPA Standard At Commands Page 15 of 60 Version 1.2
Mobile Termination errors commands
Table 4. Mobile Termination control and status commands
Command Req Description Support
+CMEE Report Mobile Termination error supported
1.9. Report Mobile Termination error( +CMEE)
Set command disables or enables the use of result code +CME ERROR: <err> as an
indication of an error relating to the functionality of the MT. When enabled, MT related
errors cause +CME ERROR: <err> final result code instead of the regular ERROR final result
code. ERROR is returned normally when error is related to syntax, invalid parameters, or TA
functionality.
Table 5. +CMEE parameter command syntax
Command Possible response(s)
+CMEE=[<n>]
+CMEE? +CMEE: <n>
+CMEE=? +CMEE: (list of supported <n>s)
value
<n>:
0
disable +CME ERROR: <err> result code and use ERROR instead
1 enable +CME ERROR: <err> result code and use numeric <err> values (refer
next subclause)
2 enable +CME ERROR: <err> result code and use verbose <err> values (refer
next subclause)
1.9.1. Mobile Termination error result code (CME ERROR)
The operation of +CME ERROR: <err> result code is similar to the regular ERROR result code: if
+CME ERROR: <err> is the result code for any of the commands in a command line, none of the
following commands in the same command line is executed (neither ERROR nor OK result code shall
be returned as a result of a completed command line execution). The format of <err> can be either
numeric or verbose. This is set with command +CMEE (refer previous subclause).
<err> values (numeric format followed by verbose format):
0 phone failure
1 no connection to phone
2 phone-adaptor link reserved
3 operation not allowed
4 operation not supported
5 PH-SIM PIN required
6 PH-FSIM PIN required