Filter
Top Products
HSDPA Standard At Commands Page 34 of 60 Version 1.2
1.29. Band Selection (AT$$MBAND)
This command is used to read and write of the band selection.
Table 24. AT$$MBAND Read Command
Command TE2
Æ
MT2 $$MBAND? <CR>
Response TE2
Å
MT2
$$MBAND: [result value] <CR>
<result_code>(OK | ERROR)
Result Value
0 : auto
1 : 850MHz
2 : 2.1GHz
3 : Not Setting
Table 25. AT$$MBAND Write Command
Command TE2
Æ
MT2 $$MBAND= <Setting value> <CR>
Response TE2
Å
MT2
$$MBAND: [result value] <CR>
<result_code>(OK | ERROR)
Setting
Value
0 : auto
1 : 850MHz
2 : 2.1GMHz
Result value
0 : Fail
1 : Success
1.30. Enter PIN +CPIN
Set command sends to the MT a password which is necessary before it can be operated (SIM
PIN, SIM PUK, PH-SIM, PIN, etc.). If the PIN is to be entered twice, the TA shall
automatically repeat the PIN. If no PIN request is pending, no action is taken towards MT
and an error message, +CME ERROR, is returned to TE.
Table 26. +CPIN parameter command syntax
Command Possible response(s)
+CPIN=<pin>[,<newpin>] +CME ERROR: <err>
+CPIN? +CPIN: <code>
+CME ERROR: <err>
+CPIN=?