Filter
Top Products
HSDPA Standard At Commands Page 30 of 60 Version 1.2
Table 19. +COLP parameter command syntax
Command Possible response(s)
+COLP=[<n>]
+COLP? +COLP: <n>,<m>
+COLP=? +COLP: (list of supported <n>s)
value
<n> (parameter sets/shows the result code presentation status to the TE):
0
disable
1 enable
<m> (parameter shows the subscriber COLP service status in the network):
0 COLP not provisioned
1 COLP provisioned
2 unknown (e.g. no network, etc.)
<number>, <type>, <subaddr>, <satype>, <alpha>: refer +CLIP
1.24. Read operator names +COPN
Execute command returns the list of operator names from the MT. Each operator code
<numericn> that has an alphanumeric equivalent <alphan> in the MT memory shall be
returned.
Table 20. +COPN action command syntax
Command Possible response(s)
+COPN +COPN: <numeric1>,<alpha1>
[<CR><LF>+COPN: <numeric2>,<alpha2>
[...]]
+CME ERROR: <err>
+COPN=?
value
<numericn>: string type; operator in numeric format (see +COPS)
<alphan>: string type; operator in long alphanumeric format (see +COPS)
1.25. Informative examples
1.25.1. Operator information reading
Command: AT+COPS?
Expected response: +COPS: mode, format, name
mode possible values:
0: automatic registration
1: manual registration