Filter
Top Products
MM6854/64 Dual Band GSM Data Modem
ME 820047 Issue 1.0
Page 16 03/00
5.1.13 ATS2- Escape character
Typing ATS2? will display the decimal value of the ASCII character used as the escape character.
The default value (43) corresponds to an ASCII <+>. The value 127 disables the escape process.
Enter
ATS2=127
ATS2=43
Response
Disables the escape process.
Sets + as the escape character (default).
Notes: None
Result codes: None
5.1.14 ATS3 – Command line termination character
Typing ATS3? will display the decimal value of the ASCII character used as the carriage return
character. The default value (13) corresponds to an ASCII <CR>. Affects asynchronous operation
only.
Enter
ATS3=13
Response
Sets CR as the command line termination character (default).
Notes:
Setting any other value than 13 may cause problems
when entering commands.
Result codes: None
5.1.15 ATS4 – Line Feed character
Typing ATS4? will display the decimal value of the ASCII character used as the line feed character.
The default value (10) corresponds to an ASCII <LF>. Affects asynchronous operation only.
Enter
ATS4=10
Response
Sets LF as the line feed character (default).
Notes:
None.
Result codes: None
5.1.16 ATS5 – Backspace character
Typing ATS5? will display the decimal value of the ?ASCII character used as the backspace
character. The default value (8) corresponds to an ASCII <backspace>. Affects asynchronous
operation only.
Enter
ATS5=8
Response
Sets backspace as the backspace character (default).
Notes:
None.
Result codes: None
5.1.17 ATS6 – Pause before blind dialling
The value of this register is ignored.