Filter
Top Products
13
+FPTS: Page Transfer Status
+FPTS= Page Transfer Status
+FREV? Identify Revision
+FSPL Enable polling
+FTSI: Report the Transmit Station ID
3.8 Voice Commands
#BDR Select Baud Rate
#CID Enable Caller ID detection and reporting
format
#CLS Select Data, Fax or Voice/Audio
#MDL? Identify Model
#MFR? Identify Manufacturer
#REV? Identify Revision Level
#TL Audio output transmit level
#VBQ? Query Buffer Size
#VBS Bits per sample (ADPCM or PCM)
#VBT Beep Tone Timer
#VCI? Identify Compression Method
#VLS Voice line select
#VRA Ringback goes away timer
#VRN Ringback never came timer
#VRX Voice Receive Mode
#VSDB Silence deletion tuner
#VSK Buffer skid setting
#VSP Silence detection period
#VSR Sampling rate selection
#VSS Silence deletion tuner
#VTD DTMF tone reporting capability
#VTM Enable timing mark placement
#VTS Generate tone signals
#VTX Voice transmit mode
Section Four - S Registers
Your modem has 41 registers, designated S0
through S95. Table 4-1 shows the registers, their func-
tions, and their default values. Some registers can have
their values changed by commands. If you use a com-
mand to change a register value, the command remains
in effect until you turn off or reset your modem. Your
modem then reverts to the operating characteristics
specified in its non-volatile memory. Refer to Section 3
for information on how to use the AT commands to
manipulate the S registers.