Filter
Top Products
18
Data format: 300-115200 bps
Power: 0.75 W
Temperature: 0 to 55 degrees C (Operating)
Caller ID: Yes
PnP: Revision 1.0a
Speakerphone: Full-duplex with DSP echo
cancellation
Appendix B - Speaker Type Selection
Your modem supports both mono and stereo speakers. Use
jumper JP3 to select the speaker type. The modem is factory set
to use stereo speakers (jumper over both pins). If you use a mono
speaker, remove the jumper (See Figure B-1).
Figure B-1 Speaker Type Jumper JP3
Appendix C - Notices
FCC Compliance
This equipment complies with Part 68 of the FCC Rules. On this
equipment is a label that contains, among other information, the
FCC registration number and Ringer Equivalence Number
(REN) for this equipment. You must, upon request, provide this
information to your telephone company.
If your telephone equipment causes harm to the telephone
network, the Telephone Company may discontinue your ser-
vice temporarily. If possible, they will notify in advance. But, if
advance notice is not practical, you will be notified as soon as
possible. You will be informed of your right to file a complaint
with the FCC.
Your telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect proper
operation of your equipment. If they do, you will be notified in
advance to give you an opportunity to maintain uninterrupted
telephone service.
The FCC prohibits this equipment to be connected to party lines
or coin-telephone service.
In the event that this equipment should fail to operate properly,
disconnect the equipment from the phone line to determine if it
is causing the problem. If the problem is with the equipment,
discontinue use and contact your dealer or vendor.
STEREO
MONO