Filter
Top Products
INTERFACE COMMANDS
7 – 6
Set Feature Commands
Set Features Mode
Enables or disables features supported by the drive. When the drive receives this command it:
1. Sets BSY,
2. Checks the contents of the Features register,
3. Clears BSY and
4. Generates an interrupt.
If the value of the register is not a feature supported by the drive, the command is aborted.
The acceptable values in the Features register are defined as follows:
EULAVNOITPIRCSED
*h20ehcacetirwdelbanE
h30retsigertnuoCrotceSnieulavnodesabedomrefsnartteS
h44 ehtnideificepssdnammocgnoLetirW/gnoLdaeRnodedneppaatadfohtgneL
noitamrofnieciveDyfitnedI
h55erutaefdaeha-kooldaerelbasiD
*h66stluafedno-rewopotgnitreverelbasiD
h28ehcacetirwelbasiD
*hAAerutaefdaeha-kooldaerelbanE
*hBB sdnammocgnoLetirW/gnoLdaeRnodedneppaatadcificepsrotxaMfosetyb4
hCCstluafedno-rewopotgnitreverelbanE
*.tluafedybpurewoptadelbanE