Filter
Top Products
1
ANALOG CODES
CS1000 Code Scanner
OB15-11
42
Model Model Years
140.032 1992-1993
Connect wires of Scanner as follows
Scanner Data Link Connector 38-pin
Yellow Socket 17
Black Socket 1
Red Socket 3
FAULT CODE TABLE
DTC Readout Possible Cause of Failure
1 No fault found
2 Maximum retard setting on at least one cylinder has been reached
3 Not used
4 Load sensor in ignition control module faulty.
5 Knock sensors 1 and/or 2 faulty.
6 Camshaft position sensor faulty.
7 Knock output switch in ignition control module faulty.
8 Transmission overload switch does not close.
9 Transmission overload switch does not open.
10 Not used.
11 Preference resistor faulty .
12 Tn-signal is outside the tolerance range.
13 Not used
14 Not used
15 Ignition coil 1 output from ignition control module faulty
16 Ignition coil 2 output from the DI defective or primary winding of the coil has an open
circuit
17 Crankshaft position sensor faulty
18 Magnets for crankshaft position sensor (CKP) not recognized.
19 Not used