Filter
Top Products
35
DEFAULT SETTINGS – COMMUNICATION PARAMETERS
Many functions of the scanner can be “configured” – that is, enabled or disabled.
The scanner is shipped from the factory configured to a set of default conditions.
The default parameter of the scanner has an asterisk (*) in the charts on the
following pages. If an asterisk is not in the default column then the default setting
is OFF or DISABLED.
PARAMETER DEFAULT PARAMETER DEFAULT
Multi-Try Trigger Out-of-Stand
*
Data Matrix
Presentation Mode In-Stand
*
QR Code
Continuous Trigger
Maxicode
Single Trigger
Aztec
Aiming in
Trigger and Continuous Modes
*
Postals
Aiming in Presentation Mode
Mod 43 Check on Code 39
Long-Range In-Stand
*
MSI-Plessy 10/10 Check Digit
Short-Range In-Stand
MSI-Plessy Mod 10 Check Digit
*
Long-Range Out-of-Stand
*
Paraf Support ITF
Short-Range Out-of-Stand
ITF Symbol Lengths Variable
RangeGate Mode
Symbol Length Lock None
Inventory Mode
Beeper tone Normal
UPC/EAN
*
Beep/transmit sequence
Before
transmit
Code 128
*
Communication timeout None
Code 93
*
Razzberry tone on timeout
Codabar
*
Three beeps on timeout
Interleaved 2 of 5 (ITF)
*
Same symbol rescan timeout:
1000 msecs
*
MOD 10 check on ITF
Code 11
Same symbol rescan timeout
configurable in 50 msec steps
(maximum of 6.35 sec.)
Code 39
*
No Same symbol timeout
Full ASCII Code 39
Infinite Same symbol timeout
PDF
*