Filter
Top Products
15
CONFIGURATION OF THE MS6130 HAND-HELD
To perform matching procedure refer to page 18.
Before the MS6130 scanner ships from the factory, the factory programs the
scanners to a set of default settings. These default settings can be found in
the MS4120 Programming Guide. The default settings have an asterisk that
appears before the brief definition located near the bar code. Once RF
communication establishes, change the default settings of your scanner to
meet your individual scanning needs. Configure the scanner by scanning
the Transmitter Enter/Exit Program Mode bar code and the appropriate bar
codes in the MS4120 Programming Guide.
For example, to program the MS6130 not to read ITF
(Interleaved 2 of 5) bar code types:
• With the MS6130, scan the Enter/Exit Program Mode bar code in the
MS4120 Programming Guide, the Disable ITF bar code, then the
Enter/Exit Program Mode bar code again.
Note: When the MS6130 is in program mode, never scan any of the
RS-232 or light pen options marked with an “R”. The list of
options is in the Default Settings of the Transmitter and “MX”
Receiver section of this guide when using the MS4120
Programming Guide. The MS6130 is in program mode when
scanning the Enter/Exit Program Mode bar code in the
MS4120 Programming Guide.