Filter
Top Products
6
INSTALLATION FOR STAND-ALONE KEYBOARD INTERFACE
1. Turn off the host system.
2. Disconnect the keyboard from the host.
3. Connect the PowerLink cable to the 10-pin
Stand-Alone Keyboard interface jack. It is
the 2
nd
round opening from the left side of
the MS7320 (see figure 3).
4. Connect the other end of the PowerLink
cable to the keyboard port on the host.
Before continuing verify that the
PowerLink cable is connected to the
appropriate interface jack on the scanner.
An incorrect cable connection can cause
communication problems or potential
damage to the scanner.
5. Connect the external power supply to the
power jack on the PowerLink cable.
6. Check the AC input requirements of the
power supply to make sure the voltage
matches the AC outlet.
7. Connect AC power to the transformer.
The outlet should be near the equipment
and easily accessible.
8. Scan the two bar codes in numbered
sequence in order to configure the
MS7320 for Stand-Alone Keyboard
communication.
Note:
When scanning the bar codes, cover the
code not
being scanned to ensure the
codes are read in the proper sequence.
9. Turn on the host system.
10. Snap on the cable cover.
See SELV Power Source caution statement located on page 16 of this manual.
³999994
Scan 1
S
t
Load Keyboard
Wed
g
e Defaults
³5155153
Scan 2
n
d
Enable Stand-Alone
Keyboard Wedge
Figure 3: Stand-Alone Keyboard
Interface