Filter
Top Products
Microboards CopyWriter Live
10
Copying a Disc
To copy a disc, all you need to do is place a blank disc in one drive and the master disc in
the other drive. It does not matter which drive contains the master and which drive
contains the blank. Press the Disc Copy button on the CopyWriter Live front panel and
the copy process will begin. Please follow these steps to copy a disc.
1. Place your master disc you wish copied into either of the two recorders. The
display for that drive will change to read the type of disc it is, such as Data CD or
Audio CD.
2. Place your blank CD-R or CD-RW disc into the other recorder. The display will
change to CD-RW or CD-R, depending on the type of blank disc you are using. It
will also display the total time available on that disc.
3. Press the Disc Copy button on the front panel.
4. The copy process will now start. The display will show you the progress of the
copy job.
NOTE: If your master disc is larger than your blank disc, you will see the message
SPACE NOT ENOUGH. If you see this message, you will need to use a higher
capacity blank disc.
CopyWriter Live Menu Options
Pressing the Yes/Setup button while no recording or playback is taking place will take
you into the Setup menu. Pressing the Yes/Setup button at each displayed item will
allow you to make changes to the specified setting.
Input
This menu option allows you to switch the default input selection. Note that you can
change the input selection at any time except during recording by pressing the Input
button, but this will not change the selection that first appears when the CopyWriter Live
is turned on. The CopyWriter Live default for input selection is Input 1.
Choices for the input selection are INPUT 1, INPUT 2, XLR, and MIC.
Volume
You can control the input volume for each input selection of the CopyWriter Live
system. A different volume level can be saved for each input selection.
Press the Yes/Setup button to change the volume for the displayed input selection, or No
to move to the next selection. After pressing Yes/Setup, use the Vol Up and Vol Down
buttons to change the volume setting for the input selection. Press Yes/Setup again to
save the new volume level and return to Volume in the Setup menu. Pressing No will
discard the changes.
The input volume can also be controlled during recording by using the Vol Up and Vol
Down buttons.