Filter
Top Products
7
Figure 1. Combine the Switch with the provided screws
Then, use screws provided with the equipment rack to mount each switch in the rack.
Figure 2. Mount the Switch in the rack
Connecting Network Cable
The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and it runs both in half
and full duplex mode using two pair of Category 5 cable.
The Switch also supports 2-Ports 1000Mbps Gigabit Ethernet that runs in Auto-
negotiation mode and 10Mbps Ethernet or 100Mbps Fast Ethernet that runs both in half
and full duplex mode and 1000Mbps Gigabit Ethernet runs in full duplex mode using four
pair of Category 5 Cable.
These RJ45 ports are Auto-MDI type port. The Switch can auto transform to MDI-II or
MDI-X type, so you can just make an easy connection that without worrying if you are
using a standard or crossover RJ45 cable.
There are additional two mini-GBIC ports for optional mini-GBIC module.
AC Power
The Switch used the AC power supply 100-240V AC, 50-60 Hz. The power switch is
located at the rear of the unit adjacent to the AC power connector and the system fan. The
switch’s power supply will adjust to the local power source automatically and may be
turned on without having any or all LAN segment cables connected.