Filter
Top Products
14
View Trap: The Trap function can receive the events that happen from the Web
Management Switch in the Monitor List.
There is a light indicator behind the “View Trap” button, when the light indicates in green,
it means that there is no trap transmitted, and else when it indicates in red, it means that
there is new trap transmitted, this is to remind us to view the trap. (Figure 7)
Figure 7.
When the “View Trap” button is clicked, a Trap Information window will pop out, it will
show the trap information including the Symbol, Time, Device IP and the Event occured.
(Figure 8)
The symbol “
” represents the trap signal arise, this symbol will disappear after you
review and click on the event record.
Figure 8.
Note: In order to receive Trap information, switch has to be configured with Trap IP and Trap Events
in Web browser, which are available in the Trap Setting Menu (see Page 40 for detail).
Add Item: To add a device to the Monitor List manually, enter the IP Address of the
device that you want to monitor.
Delete Item: To delete the device in the Monitor List.
Device Setting
You can set the device by using the function key in the Device Setting Dialog box.
Configuration Setting: In this Configuration Setting, you can set the IP Address, Subnet
Mask, Gateway, Set Trap to (Trap IP Address), System name and Location.
Select the device in the Discovery list or Monitor List and press this button, then the
Configuration Setting window will pop out as Figure 9, after filling up the data that you
want to change, you must fill up the password and press the “Set” to process the data
changed immediately.