Filter
Top Products
Micronics M5Pi System Board Manual
3-6
Installing a CPU
The M5Pi is designed to support 60 or 66MHz Pentium processors. Follow
the steps below to install a processor:
1. Turn off the computer and remove the computer cover.
2. Locate the ZIF socket illustrated in Figure 2-1.
3. Lift the lever of the socket.
4. Locate pin 1 on the processor and pin 1 on the socket (Figure 2-1).
Gently set the processor into the socket, making sure
pin 1 on the processor and pin 1 on the socket are aligned.
5. Push the lever down until it locks into place.
6. Make sure the CPU selection jumpers are set correctly (Chapter 2).
Warning:
Pentium processors require a heat-sink with a cooling fan. Failure to
provide adequate cooling of the processor may seriously affect system
performance or cause permanent damage to the processor.