Filter
Top Products
MINILINK WIRELESS ETHERNET SYSTEM (WES)
The MiniLink WES is a plug and play CAT5/Ethernet cable replacement device. It operates in the
5.8 GHz U-NII bands on 5 non-overlapping channels. The WES system enables a wide variety of
IP cameras, DVRs, encoders/decoders and web servers to be used across wireless line-of-sight links
in ranges of 500 feet to 30 miles. The system operates independent of any network it may be
connected to.
MINILINK WIRELESS ETHERNET MODULE (WEM)
WEM DESCRIPTION
A. FRONT VIEW B. REAR VIEW
NOTE: Mount
Host/Client so that
Vertical Ethernet
Port is at bottom and
use weatherproof
caps and plugs for
outdoor use as
described on pg 7.
5
1. LINK ACTIVITY LED
Indicates that an Ethernet cable connection between powered Ethernet device & Host or
Client has been established.
1 2 3 4
2. POWER LED
Indicates the Host or Client has power.
3. SIGNAL LEVEL LED
Indicates the signal strength level between Host/Client. On the MP Host AP, indicates the
number of connected Clients.
Note: This is not an indication of available throughput.
4. ETHERNET PORT
Standard RJ-45 connector. Outdoor use- must be weather protected with supplied strain-
relief positioned so the connector is at bottom of the case. Weatherproof strain-relief plug
should be tight enough so that it is snug on the cable but not to restrict cable movement.
5. CHANNEL SELECT
Rotary switch for channel selection, factory set to Channel 0. Switch is positioned on the
side of the gray case behind the weatherproof plug.
Plug must be resealed after channel change.
C. BOTTOM VIEW
D. SIDE VIEW
1 2
3
1. ETHERNET PORT
Standard RJ-45 Connector
2. MOUNTING HOLES
(3) ¼ - 20 mounting holes. Two vertical holes
for dish L-bracket (ML WES-12 / ML WES-30
/ ML WSUDI). Far right hole for black swivel mount.
3. ROTARY CHANNEL SELECT
SWITCH
(REMOVE WEATHERPROOF PLUG)
Shows switch settings for channels 0 – 7.
REPLACE (RESEAL) WEATHERPROOF PLUG
AFTER CHANNEL
SELECT CHANGE AND
POWER CYCLE
- 4 -