Filter
Top Products
7.1 Specifying Finishing Settings
7
Di2010/Di2510/Di3010/Di3510 7-5
Specifying Copy Settings Chapter 7
<Only when the finisher and the saddle kit are installed>
● Creased and 2-Point Staple
Automatically crease paper copied
in booklet-printing mode, and sta-
pled together at two points in the
center.
✎
Note
Thick paper, envelopes and over-
head projector transparencies
cannot be creased and 2-point
stapled.
✎
Tip
As a default, “Non-Sort” or “Sort” are automatically selected depending on the
number of pages in the document. The default setting is “Non-Sort”. The default
setting can be changed using a function on the User’s Choice screen. For de-
tails, refer to “Changing Default Settings” of “Utility Mode Operations” in the Ad-
vanced Operations volume of the User Manual.
Notes on Using the “Sort” and “Group” Settings
● If a document positioned on the original glass is copied using the “Sort” setting,
copying is automatically performed using the “Separate Scan” function.
For details, refer to “Auxiliary Functions” in the Advanced Operations volume of
the User Manual.
● If the finisher or the mail bin kit is installed, each set of copies is fed out shifted
to alternating sides.
● If the job tray is installed, but the finisher or the mail bin kit is not, each set of
copies is fed out in an alternating crisscross pattern.
<Conditions for crisscross sorting>
● Paper of the same type must be loaded horizontally in one paper drawer and
vertically in another drawer.
● The “Mixed Orig Detection” function must not be selected.
● None of the following can be selected: a stapling or the “Hole Punch” setting and
the “Page Insertion”, the “Cover Mode” and the “Image Repeat” functions.
● A paper drawer cannot be selected.
● Letter sized paper is set horizontally or vertically.
● If a finisher is installed, crisscross sorting can not be carried out.