Filter
Top Products
D-6
(4) Removing the expansion hard disk drive
1. Remove the upper rear cover, the rear cover, the
I/F CLAN circuit board cover, the reinforcing plate
and the connector bracket.
2. Disconnect the connector from CN4 on the CLAN
circuit board.
4599U035AA
3. Disconnect the copier's relay harness from the
wire holder.
NOTE
Harness types differ between those for copiers and
those for fax machines.
4599U041AA
4. Remove the mechanical circuit board cover (5
screws).
NOTE
Make sure that the harness on the right side of the
mechanical circuit board cover is not pinched.
4599U039AA
5. Disconnect the flat cable from the hard disk drive.
✽
When connecting the flat cable to the hard disk
drive, align the cable with the side of the hard disk
drive marked with
▼
, and then connect the flat
cable.
NOTE
• Connect the flat cable so that the yellow line is on
the left side of the hard disk drive.
• Four pins on the left side of the hard disk drive
remain free.
4599U023AC