Mitsubishi Electronics FD730U Projector User Manual


  Open as PDF
of 48
 
EN-42
Others (continued)
Problem Solution
The buttons on the
control panel (except
for the POWER
button) don’t function.
• PASSWORDFUNCTIONintheFEATUREmenuhasbeensettoMENUACCESSto
enable the password lock.
Cancel the password lock or contact the person in charge of management of the
projector. (See page 34.)
Abnormal sound is
heard.
• Becausethecolorwheelspinsatahighspeed,metallicsoundsmaybeheardinrare
occasions. Such symptom is not a malfunction.
If the following problem occurs after the lamp is replaced, check the following first.
Problem Solution
The projector does not
turn on.
• Fitthelampcoversecurely.(Seepages37and38.)
• Resetthelampoperatingtime.(Seepage38.)
The STATUS indicator
blinks.
• Resetthelampoperatingtime.(Seepage38.)
Maintenance
Warning:
• Donotuseammablesolvents(benzene,thinner,etc.)andammableaerosolswhencleaningtheprojectorbody
and lens. Flammable substances may ignite causing fire or breakdown while the lamp is illuminating.
Caution:
• Besuretoturnoffthelampandunplugthepowercordfromthewalloutletbeforeyouperformanymaintenance
on the projector.
• Askyourdealerforannualcleaningoftheinsideoftheprojector.Ifyoucontinuetousetheprojectorwithdust
inside, it may result in fire or malfunction.
Cleaning of the projector and the vents
Use a soft cloth to clean the projector and the vents. When the vents become dirty, wipe them with a soft cloth
dampened with diluted mild detergent, and then wipe them with a dry cloth.
To protect the surface of the projector from fading or deteriorating:
• Donotsprayinsecticideonorinsidetheprojector.
• Donotusebenzinorthinnertocleanit.
• Donotletrubberorplasticmaterialscontactwithprojector.
Cleaning of the lens
Use a standard lens-cleaning brush or a piece of lens tissue dampened with lens cleaning fluid. The lens surface is
fragile. Use only recommended, nonabrasive lens-cleaning materials. Do not touch the lens with your fingers.
Kensington Lock
This projector has a Kensington Security Standard connector for use with Kensington MicroSaver Security System.
Refer to the information that came with the Kensington System for instructions on how to use it to secure the
projector. Please contact Kensington Technology Group below.
Kensington Technology Group
2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone:+1-(650)572-2700 Fax:+1-(650)572-9675
Troubleshooting (continued)
 previous next