Filter
Top Products
EN-19
Press the POWER button on the projector or the OFF (13. ) button on the remote control.
A confirmation message is displayed.•
To cancel the procedure, leave the projector for a while or press the MENU button.•
Press the POWER button on the projector or the OFF (14.
) button on the remote control again.
The lamp goes out and the projector goes into a standby mode. In this standby mode, the STATUS indicator •
blinks green.
Wait about 2 minutes.15.
During this period of 2 minutes in the standby mode, the intake fan and exhaust fan rotate to cool the lamp.•
The lamp can’t be lit again for 1 minute after turning off the projector for safety purpose. It will take another 1 •
minute for the STATUS indicator to go out. If you want to turn on the projector again, wait until the indicator
goes out, and then press the POWER button.
The air outlet fans rotate faster as the temperature around the projector rises.•
Do not turn off the main power switch or unplug the power cord while the STATUS indicator is blinking. Turning •
off the main power switch or unplugging the power cord immediately after use may cause a breakdown.
Though the fan makes loud sound during cooling, such symptom is not a malfunction.•
Turn off the main power switch.16.
The POWER indicator will go out.•
If the main power switch should be turned off or the power cord should be unplugged accidentally while either •
the air inlet fan or the air outlet fans are operating or the lamp is on, allow the projector to cool down for 10
minutes with the power off. To light the lamp again, press the POWER button. If the lamp doesn’t light up
immediately, repeat pressing the POWER button 2 or 3 times. If it should still fail to light up, replace the lamp.
Cover the lens with the lens cap to protect it from dust.•
For safety’s sake, unplug the power cord from the outlet.•
Viewing video images (continued)
Adjust with the 10. t or u button to get an approximate size.
When the ENTER button is pressed while • “ZOOM” is displayed, the adjustment mode is switched between
FAST and STEP. When FAST is selected, the speed of zoom controlled by the t or u button becomes fast,
and it becomes slow when STEP is selected.
Press the LENS SHIFT button. The LENS SHIFT menu appears at the center of the screen.11.
Press the 12. p or q button to adjust the vertical position and t or u button to adjust the horizontal position of the
displayed image.
When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle. (See page 10.)•
Repeat steps 4 to 5 and 9 to 12, if necessary.
To stop projecting:
OFF ( ) button
POWER button
STATUS indicator
POWER indicator