Filter
Top Products
EN-37
Replacing the lamp (continued)
To replace the lamp:
Turn off the main power switch and unplug the 1.
power cord.
Loosen two screws (a) using a Phillips screwdriver 2.
(+) and remove the left side panel from the
projector.
(a)
Loosen the screw (b) using a Phillips screwdriver 3.
(+), and remove the lamp cover (c).
(b)
(c)
Loosen the screws (d) using a Phillips screwdriver 4.
(+).
(d)
Pull the handle.5.
Pull out the lamp box by the handle while holding 6.
the projector.
Pull the lamp box out of the projector slowly. •
If it is pulled out quickly, the lamp may break
scattering glass fragments.
Do not spill liquid on the removed lamp box or •
do not place it near any flammable object or
where children can reach to prevent injury or
fire.
Load a new lamp box securely into the projector in 7.
the right orientation.
Put the handle back to the original position.8.
Make sure that the handle is locked.•
Tighten up the screws (d) using a Phillips 9.
screwdriver (+).
(d)
Tighten up the screw (b) using a Phillips 10.
screwdriver (+) to secure the lamp cover (c).
(b)
(c)
Attach the left side panel to the projector and fix it 11.
with two screws (a).
(a)(a)
Reset of the lamp operation time
Plug the power cord into the wall outlet and turn on 12.
the main power switch.
Hold down the 13. t, u, and POWER buttons on the
control panel at the same time about 3 seconds.
Important:
Unless these 3 buttons are • held down at the same
time, the lamp operation time isn’t reset.
Make sure that the STATUS indicator blinks twice •
and the lamp operation time is reset successfully.
The projector doesn’t turn on if the lamp cover isn’t •
attached securely.
Be sure to reset the lamp operation time whenever •
you replace the lamp.
Do not reset the lamp operation time unless you •
replace the lamp.
The lamp is fragile. If it is broken, be careful not to •
cut yourself with glass fragments.
Caution:
This projector uses a lamp that •
contains mercury. Disposal of the lamp
or the projector with the lamp may
be regulated due to environmental
considerations. For disposal or
recycling information, please contact
your local authorities or the Electronic
Industries Alliance: www.eiae.org. (For
the U.S. only.)