Filter
Top Products
EN-35
Password function
This projector is equipped with the password function
that is designed for prevention of theft and wrong
operation by children and restriction on operation by
other than specified users. The password function has
two modes as follows.
DISPLAY INPUT .......... When the projector is turned
on, the startup screen (or splash screen) will appear
and stay on the screen until the password is
entered. When the password is entered, the startup
screen will switch to the regular operation screen.
MENU ACCESS ........... All the buttons except for the
POWER button on the projector are disabled. (The
buttons on the remote control are enabled.) You
can use this mode as a measure of prevention
of wrong operation by children and restriction on
operation by other than specified users.
To enable the password function:
Display the FEATURE menu.1.
Press the 2. p or q button to select PASSWORD
FUNCTION.
Press the 3. u button to change the mode among
DISPLAY INPUT
and MENU ACCESS .
When the password has already been set, the •
mode won’t be changed. In such cases, press
the ENTER button to cancel the password
function and try again.
Press the ENTER button.4.
The screen for setting the password function will •
appear.
DISPLAY INPUT
LOCK
UNLOCK
OK
OK
Press the ENTER button.5.
The screen for entering a password will appear.•
PASSWORD
CONFIRM
1
3
24
O K : ENTER CANCEL : MENU
Enter a 4 - 8 digit password using the 6. p, u, q or
t
buttons on the remote control as shown below.
(
p=1, u=2, q=3, t =4)
Press the ENTER button.7.
To cancel the procedure, press the MENU •
button.
Enter the password again for confirmation using the 8.
same steps.
Press the ENTER button. 9.
If the entered passwords don• ’t match, an error
message will appear.
To cancel the procedure, press the MENU •
button.
Advanced features
To cancel the password function:
Display the FEATURE menu.1.
Press the 2. p or q button to select PASSWORD
FUNCTION.
Press the ENTER button.3.
The screen for canceling the password function •
will appear.
DISPLAY INPUT
LOCK
UNLOCK
OK
OK
Press the ENTER button.4.
The screen for entering the password will •
appear.
PASSWORD
1
3
24
O K : ENTER CANCEL : MENU
Enter a 4 - 8 digit password using the 5. p, u, q or
t
buttons on the remote control as shown below.
(
p=1, u=2, q=3, t =4)
Press the ENTER button.6.
If you enter a wrong password, an error •
message will appear.
To cancel the procedure, press the MENU •
button.
Important:
Disable the password by pressing the MENU and •
ENTER buttons on the control panel at the same
time about three seconds.
Kensington Lock
This projector has a Kensington Security Standard
connector for use with Kensington MicroSaver
Security System. Refer to the information that came
with the Kensington System for instructions on how
to use it to secure the projector. Please contact
Kensington Technology Group below.
Kensington Technology Group
2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone: +1- (650)572-2700
Fax: +1- (650)572-9675