Filter
Top Products
EN – 17
ENGLISH
5 SIGNAL
HORIZ. POSITION ....
Use to adjust the horizontal position of the image.
VERT. POSITION .....
Use to adjust the vertical position of the image.
FINE SYNC. ....... Use to synchronize the projector with PC input signals so
that the image is not blurred.
TRACKING .........Use to avoid image noise such as wide stripes.
COMPUTER INPUT ....
The unit adjusts itself automatically when connected to
either DVD players with a component video output
terminal (YCBCR or YPBPR) or equipment with HDTV
signal output capabilities. In cases where the unit is
connected to equipment that include an RGB output terminal and which output HDTV
signals, adjust the unit to RGB mode.
• In case of the HDTV, you cannot adjust the horizontal position and the vertical position of the image.
6 SIGNAL - USER (Normally, there is no need for adjustments.)
HOLD BEGIN /
HOLD END...... Adjusts the image when curving near the top.
CLAMP POSITION/
CLAMP WIDTH .........
If you use something similar, the brighter colors of the
projected image may become blurred. In this case, adjust
CLAMP POSITION or CLAMP WIDTH.
ANAMORPHIC... Set to ON when displaying DVD discs which are recorded
as squeezed images (in right and left direction).
HOLD BEGIN
USER
HOLD END 1
1
CLAMP POSITION 0
CLAMP WIDTH 0
ANAMORPHIC ON
USER
R G B
Opt
HORIZ. POSITION
SIGNAL
VERT. POSITION 0
0
FINE SYNC. 0
TRACKING 0
COMPUTER INPUT RGB
R G B