Filter
Top Products
E-21
Power Cable Connections and Switching the Power On/Off
D
V
IA
U
D
IO
VID
E
O
S
-V
ID
E
O
STATUS
SOURCE
STANDBY
AUTO
MENU
QUICK
MENU
PC CARD
PC-CARD
STATUS STANDBY STATUS STANDBY STATUS STANDBY
There is an order in which the power cable is connected and the power is switched on/off.
Operating
1
Connect the AC IN connector of the projector and the power outlet using the supplied power cable.
The STANDBY indicator will light in amber, and the unit will enter the standby mode.
Firmly plug in all the way.
To wall outlet
2
Switch on the projector power
Main unit operation: Press the STANDBY button.
Remote control operation: Press the STANDBY ON button.
This indicator is also lit green in Low-mode.
Flashing green
(Approximately 60 seconds)
Lit green
Power is on
The first time the power is switched on after purchase, [Menu Language Select] will be displayed. See Page E-22 for
information about language selection.
• When the power is switched on, the STANDBY indicator changes to flashing green, then lights steadily after about 60
seconds and the projection screen is set to the brightness of normal mode. At this time, if the STATUS indicator is lit in
green, [Lamp Mode] is set to “Low”. See Pages E-28 and E-47 for information about the selection method.
• If the power does not come on, see “When the STATUS Indicator is Lit or Flashing” on Page E-67.
•Your own logo can be projected at the time of startup. See “Startup Logo Creation” on Page E-57.
The projector is now capable of regular projection.
3
Switch on the power of the connected equipment
Note:
• When the power plug will be unplugged from the power outlet, please place the projector near the power outlet so that it may be reached
easily.
•Press the STANDBY button or the STANDBY ON button after the STANDBY indicator is lit in amber.
STANDBY
ON OFF
STANDBY
Lit amber
STATUS STANDBY
Lit amber