Mitsubishi Electronics XD560U Projector User Manual


  Open as PDF
of 60
 
EN-8
Remote control
Battery installation
Use two (AA, R6) size batteries.
Inserting the batteries into the remote control
1. Remove the back cover of the remote control by pushing the battery compartment door in the direction of the
arrow.
2. Loadthebatteriesmakingsurethattheyarepositionedcorrectly(+to+,and-to-).
• Loadthebatteriesfrom-springside,andmakesuretosetthemtightly.
3. Replace the back cover.
Removing the batteries from the remote control
Remove the back cover of the remote control and take out the batteries.
Caution:
• Useofabatteryofwrongtypemaycauseexplosion.
• OnlyCarbon-ZincorAlkaline-ManganeseDioxidetypebatteriesshouldbeused.
• Disposeofusedbatteriesaccordingtoyourlocalregulations.
• Batteriesmayexplodeifmisused.Donotrecharge,disassemble,ordisposeofinfire.
• Besuretohandlethebatteryaccordingtotheinstructions.
• Loadthebatterywithitspositive(+)andnegative(-)sidescorrectlyorientedasindicatedontheremotecontrol.
• Keepbatteriesoutofreachofchildrenandpets.
• Removethebattery,iftheremotecontrolisnotusedforalongtime.
• Donotcombineanewbatterywithanoldone.
• Ifthesolutionofbatteriescomesincontactwithyourskinorclothes,rinsewithwater.Ifthesolutioncomesin
contact with your eyes, rinse them with water and then consult your doctor.
Operation range (of the remote control)
The maximum operation distance of the remote control is about 10 m (or about 32 feet) when the remote control is
pointed at the remote control sensor of the projector. When the remote control is pointed to the screen, the distance
from the remote control to the projector via the screen should be 5 m or less. However, the operation distance varies
depending on the type of the screen used.
Reception angle (horizontal) Reception angle (vertical)
30°30°
10°
20°
10°
20°
Reception angle (vertical), ceiling mount
20°
20°
Important:
• Donotexposetheremotecontrolsensortodirectsunlightoruorescent.Keepadistanceatleast2m(6.5feet)
between the remote control sensor and the fluorescent light to ensure correct operation of the remote control.
Inverted fluorescent light, if located near the projector, may interfere the remote control.
• Whenyouusetheremotecontroltooclosetotheremotecontrolsensor,theremotecontrolmaynotwork
correctly.
 previous next