Filter
Top Products
3-10 C168P User’s Manual
Installing Driver
Up to four C168P boards can be installed together as long as the I/O addresses and
IRQ number resources are sufficient and available in a system.
The following is the procedure for installing C168P
for the first time under
Windows 95/98:
1. Run Setup95.exe in the driver diskette.
2. Click on [Next>] button in the “Welcome ...” message dialog box. And then
click on [
Next>] button in the “Ready ...” message dialog.
3. Click on [Finish] button in the “Complete ...” message dialog to enter the
configuration panel.
4. The “Moxa Smartio/Industio Configuration Panel” dialog will pop up for you
to configure the boards and ports.
5. In the “Moxa Smartio/Industio Configuration Panel” dialog box, click [Add]
to enter “
Property” dialog box to add the C168P board. Select the “C168
Series”
in the “Board Type” field. If necessary, type the desired interrupt vector
address, in the “INT Vector” field. Select the desired interrupt number in the
“Interrupt No.” field. Type the desired base I/O address, in the “Base I/O Port
Address” field. All the settings should match settings that are physically set on
the board and conflict with no other devices.