CP-132U Series User’s Manual
2-6
Installing the CP-132UL Series Board
Step 1: Power off the PC.
Warning! To avoid damaging your system and board, make sure your computer is turned off
before installing any board.
Step 2: Remove the PC’s cover.
Step 3: Remove the slot cover bracket if there is one.
Step 4: Plug the CP-132U Series control board firmly into a free 32-bit PCI slot or 64-bit
PCI slot.
Step 5: Fasten the holding screw to fix the control board in place.
Step 6: Replace the system cover.
Step 7: Power on the PC. The BIOS will automatically set the IRQ and I/O address.
Note! Moxa Universal PCI or PCI boards will occupy one unique IRQ and I/O address,
which are assigned automatically by the PCI BIOS.
Step 8: Proceed with the software installation discussed in the next chapter, “Software
Installation.”