Moxa Technologies CP-132U Series Switch User Manual


 
CP-132U Series User’s Manual
A-2
Power requirement CP-132UL 220 mA (+5V)
CP-132UL V2 120 mA (+5V)
CP-132U-I 578 mA (+5V)
CP-132UL-I V2 490 mA (+5V)
Dimensions (W × D) CP-132UL 120 × 64.5 mm
CP-132UL V2 120 × 64.5 mm
CP-132U-I 120 × 100 mm
CP-132UL-I V2 120 × 64.5 mm
PCI
The 32-bit CP-132UL Series board complies with PCI Specifications 2.1. The IRQ and I/O
address hardware configuration is automatically assigned by the PCI BIOS. This means that
you must first plug in the board before installing the driver software.
As opposed to ISA slots, different PCI slots in the same PC may have different bus
numbers and device numbers with respect to the PCI specifications. The same PCI board
will have different system configurations if switched to a different PCI slot; this is called
slot-sensitive or slot-dependent. This may also apply to PCI slots in a PC with a different
motherboard, which may use different device number sets. For example, some use 17, 18,
19, and 20 for identifying the respective PCI slots, but some use 11, 12, 13 and 14.
Due to slot-dependency, it is necessary to re-configure the driver software once the
board is plugged into different PCI slots.
Up to 4 CP-132UL Series boards are allowed in one system. When installing more than one
board, please remember the order the boards are installed to distinguish the installed
boards from each other.
.