Filter
Top Products
NPort 5600 Series User’s Manual Initial IP Address Configuration
2-6
To set a termination resistor to 150 KΩ, make sure both of the assigned DIP switches are in the
OFF position. This is the default setting.
To set a termination resistor to 1 KΩ, make sure both of the assigned DIP switches are in the ON
position.
ATTENTION
Do not use the 1 KΩ setting on the NPort 5650 when using the RS-232 interface. Doing so will
degrade the RS-232 signals and shorten the maximum allowed communication distance.
NPort 5650 DIP Switches
S1 for Port 1
S2 for Port 2
S3 for Port 3
S4 for Port 4
S5 for Port 5
S6 for Port 6
S7 for Port 7
S8 for Port 8
S9 for Port 9
S10 for Port 10
S11 for Port 11
S12 for Port 12
S13 for Port 13
S14 for Port 14
S15 for Port 15
S16 for Port 16