Filter
Top Products
NPort 5600 Series User’s Manual Configuring NPort Administrator
5-19
ATTENTION
Inactivity time is ONLY active when “TCP connect on” is set to “Any character.”
Ignore jammed IP
Setting Factory Default Necessity
No or Yes No Required
For previous versions of NPort 5200, when Max connections > 1, and the serial device is
transmitting data, if any one of the connected hosts was not responding NPort 5200 would wait
until the data had been transmitted successfully before transmitting the second group of data to all
hosts. For the current version of NPort 5200, if you select Yes for “Ignore jammed IP,” the host
that is not responding will be ignored, but the data will still be transmitted to the other hosts.
Allow driver control
Setting Factory Default Necessity
No or Yes No Required
If “max connection” is greater than 1, NPort will ignore driver control commands from all
connected hosts. However, if you set “Allow driver control” to YES, control commands will be
accepted. Note that since NPort 5200 may get configuration changes from multiple hosts, the most
recent command received will take precedence.
Packing length
Setting Factory Default Necessity
0 to 1024 0 Required
Default = 0, The Delimiter Process will be followed, regardless of the length of the data packet. If
the data length (in bytes) matches the configured value, the data will be forced out. The data length
can be configured for 0 to 1024 bytes. Set to 0 if you do not need to limit the length.
Delimiter 1
Setting Factory Default Necessity
00 to FF None Optional
Delimiter 2
Setting Factory Default Necessity
00 to FF None Optional
Once the NPort receives both delimiters through its serial port, it immediately packs all data
currently in its buffer and sends it to the NPort’s Ethernet port.