Filter
Top Products
MRV Communications, Inc. – Installation Manual
33
2 - TS5000/155 & TS5000/155-F
Compatibility
Peripheral equipment
Check the operating of the peripheral equipment connecting them through cables
(see Configuration 1 below).
Interfaces
Check the specifications compatibility (type, wavelength, receiver range, output
power, data rate) between the TereScope and the peripheral equipment interfaces.
Testing equipment
Chose an appropriate BER (Bit Error Rate) tester for checking the physical link
quality. A portable one is preferred for convenient use in the field.
For example: the OC3port plus SONET and ATM analyser manufactured by
Fluke.
A ping test or a file transfer between two workstations - connected to the
networking equipment - is useful and easy to implement for testing the
performance of the whole configuration.
Setup
Data Rate DIP Switch Toggle
According to the application in use, set the switch DS1 toggles as indicated in the
following table:
Table 7: DIP Switch Setting for TereScope
TS5000/155
Function
OFF ON
Fast Ethernet
1,2,3,4 –
ATM/OC3/STM1: 155 Mbps
2,3,4
1
SMPTE 143 Mbps
3,4
1,2
E3:34.368 Mbps 1,2,4 3
T3:44.736 2,4 1,3
OC1/STMO:51.840 Mbps 1,4 2,3
Customized 1 4 1,2,3
Customized 2 1,3,4 2
Open Protocol 1,2,3 4
Mode Select DIP switch toggle
Set DIP switch toggles 1, 2 and 4 to the OFF position for normal operation.
3 - TS5000/ETH
Compatibility
Peripheral equipment
Check the operating of the peripheral equipment connecting them through cables
(see Configuration 1 below).