Filter
Top Products
3-9
BIOS Setup
Hard Disk Boot Priority
Press <Enter> to enter the sub-menu and the following screen appears:
In the sub-menu, it shows the hard disks information that was installed in the
system, and you can set the hard disk boot priority.
IOAPIC Function
This field is used to enable or disable the APIC (Advanced Programmable Interrupt
Controller). Due to compliance with PC2001 design guide, the system is able to run in
APIC mode. Enabling APIC mode will expand available IRQ resources for the system.
Settings: [Enabled], [Disabled].
MPS Table Version
This field allows you to select which MPS (Multi-Processor Specification) version to
be used for the operating system. You need to select the MPS version supported by
your operating system. To find out which version to use, consult the vendor of your
operating system. Setting options: [1.4], [1.1].
Boot to OS/2
This allows you to run the OS/2
®
operating system with DRAM larger than 64MB.
When you choose [No], you cannot run the OS/2
®
operating system with DRAM larger
than 64MB. But it is possible if you choose [Yes]. Setting options: [Yes], [No].