Filter
Top Products
16
MultiFRAD 3000-Series User Guide
4 Connect the MultiFRAD to a PC using an appropriate RS232 cable. Plug the male end of the
cable into the Command Port on the back of the MultiFRAD and the other end into the pc’s
serial port. See Figure 3.
5 Connect one end of the power supply to a live AC outlet and connect the other end to the
MultiFRAD as shown in Figure 3. The power connector is a 7-pin circular DIN connector.
6 Turn on power to the MultiFRAD by placing the ON/OFF switch on the back panel to the ON
position.
At this time your MultiFRAD is completely cabled. Proceed to the next section to load your software.