Filter
Top Products
Software/Driver Installation
62 MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD
SCO Open Server 5 Driver Installation
The installation utility provided by SCO is called custom. This section
describes opening the utility and installing the driver. The instructions
below should be used only on SCO Open Server 5 systems. When you
have completed the steps below, go to Multi-Tech Installation Script,
which immediately follows this section.
1. Insert the driver diskette into a floppy drive. If installing the driver
from your default floppy drive, type custom and press ENTER
to open the custom utility. If using a nondefault drive, you must
inform your system of the disk drive from where you are doing the
installation and specify the size and capacity of the diskette(s).
2. Select Software and press ENTER.
3. The main menu displays a list of options. Press ENTER to select
the highlighted item (default): Install.
4. Select From comsco and press ENTER. (Comsco is a sample
server name.)
5. Make sure the driver diskette is in the floppy diskette drive and
then press ENTER to select the highlighted item (default):
Floppy Disk Drive 0. The following message appears:
Examining media. Please wait
6. The system recognizes that you are installing the Multi-Tech Serial
Card Driver and prompts you to select the type of installation.
7. (A) In version 5.0.2, select Full Installation and press
ENTER to continue. The following messages appear:
Extracting Files...
Executing Multi-Tech Serial Card
Driver Init Script...
(B) In versions 5.0.4 and 5.0.5, press ENTER twice, or tab down to
install and press ENTER.
8. When installation finishes, this prompt appears:
Do you wish to continue ( y / n / q ):?
Type Y and press ENTER. A message appears and you can begin
configuring your system with the MultiTech Installation Script.