Filter
Top Products
41
Chapter 4 - Commands
VALUES: n = 4 or 5
DEFAULT: &T5
DESCRIPTION: &T4 selects Enable Response to Request for Remote
Digital Loopback.
&T5 selects Disable Response to Request for Remote
Digital Loopback.
COMMAND: #Tn
VALUES: n = 0 or 1
DEFAULT: #T1
DESCRIPTION: #T0 turns off Trellis Coded Modulation
#T1 turns on Trellis Coded Modulation
COMMAND: Un
VALUES: n = 0, 1, 2, or 3
DEFAULT: n/a
DESCRIPTION: U0 places modem in Analog Loop Originate Mode.
U1 places modem in Analog Loop Answer Mode.
U2 places modem in Remote Digital Loopback test mode.
U3 places modem in Local Digital Loopback Test Mode.
COMMAND: Vn
VALUES: n = 0 or 1
DEFAULT: V1
DESCRIPTION: V0 means Result Codes sent as digits(terse response).
V1 means Result Codes sent as words (verbose response).
COMMAND: W
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Wait for new dial-tone.
COMMAND: &Wn
VALUES: n = 0 or 1
DEFAULT: &W1
DESCRIPTION: &W0 causes modem to store its current parameters in non-
volatile RAM, and modem will load these for future
sessions instead of reading factory ROM defaults, unless
&F command used.
&W1 causes modem to not store parameters.
COMMAND: Xn
VALUES: n = 0, 1, 2, 3 or 4