Filter
Top Products
35
Chapter 4 - Commands
VALUES: n = 0 or 1
DEFAULT: %DP0
DESCRIPTION: %DP0 selects do not read Line Probe Information from
DSP during handshaking.
%DP1 selects read Line Probe Information from DSP
during handshaking.
COMMAND: En
VALUES: n = 0 or 1
DEFAULT: E1
DESCRIPTION: E0 selects do not echo Command mode characters.
E1 selects do echo Command mode characters.
COMMAND: &En
VALUES: n = 0 thru 15
DEFAULT: &E1, &E4, &E6, &E10, &E13, &E15
DESCRIPTION: &E0 selects no error correction.
&E1 selects V.42 Auto-reliable Mode.
&E2 selects V.42 Reliable Mode.
&E3 selects no modem-initiated flow control.
&E4 selects CTS modem-initiated flow control.
&E5 selects Xon/Xoff modem-initiated flow control.
&E6 selects Xon/Xoff not passed through.
&E7 selects Xon/Xoff passed through.
&E8 selects Enq/Ack pacing off.
&E9 selects Enq/Ack pacing on.
&E10 selects Normal Mode flow control off.
&E11 selects Normal Mode flow control on.
&E12 selects Pacing off.
&E13 selects Pacing on.
E14 selects data compression disabled.
&E15 selects data compression enabled.
COMMAND: %En
VALUES: n=0 thru 5
DEFAULT: %E1
DESCRIPTION: %E0 = Modem Won’t Escape.
%E1 = +++ Method (default setting).
%E2 = Break Method.
%E3 = Either +++ or Break Method.
%E4 = No "OK" Response to +++
%E5 = "OK" Response to +++
COMMAND: #Fn