Filter
Top Products
53
Chapter 1 - Introduction and Description
EMC, Safety, and Terminal Directive Compliance
The CE mark is affixed to this product to confirm compliance with the following European
Community Directives:
Council Directive 89/336/EEC of 3 May 1989 on the approximation of the laws of
Member States relating to electromagnetic compatibility;
and
Council Directive 73/23/EEC of 19 February 1973 on the harmonization of the laws of
Member States relating to electrical equipment designed for use within certain voltage
limits;
and
Council Directive 98/13/EC of 12 March 1998 on the approximation of the laws of the
Member States concerning telecommunications terminal and satellite earth station
equipment.
Australian Modem Warning Notice
Modems connected to the Australian telecommunications network must have a valid
AUSTEL permit. This modem has been specifically configured to ensure compliance with
AUSTEL Standards. The following commands can affect compliance and must not be set
outside the permissible range.
Modem Commands
Command Default Permissible Range
A: Do not use —
ATB B0 Do not change
AT&G &G2 Do not change
AT&P &P1 Do not change
ATSn
see table below —
S-Register Default Permissible Range
S6 4 2–5
Call Attempts/Retries
Applications software shall be configured so that no more than 3 attempts are made to
establish a connection to a given number. (Note: if the modem can detect service tones,
up to 10 attempts can be made). There must be at least 2 seconds between call
attempts. If the call sequence is unsuccessful, there shall be a delay of at least 30
minutes before attempting to call the number again.
Warning: Failure to set the modem, and any communications software used with the
modem, to the values shown above will result in the modem being operated in a non-
compliant manner. Consequently, there would be no permit in force for this equipment,
and the Telecommunications Act 1991 prescribes a penalty of $12,000 for the connection
of non-permitted equipment.
Warning: For safety reasons, only connect AUSTEL permitted or AUSTEL certified
equipment.