Filter
Top Products
IF-200 from Muratec
10
3.2. Initial Setup
Step 1: Refer to the IF-200 Worksheet in Appendix A of this guide for the required
information. Complete the Worksheet under "Settings for your ISP/Mailbox.” Your
network system administrator can provide the data required to complete the worksheet.
Step 2: After you have completed the IF-200 Worksheet, turn on the IF-200 using the
power switch on the rear panel. The LCD screen shows messages. Follow the instructions
on the LCD screen and use the keys on the front panel to enter information. After the IF-
200 has been set up, the information remains in memory, even if the power is turned off.
After the power is turned on, the Welcome screen appears after a few seconds.
Press any key to start the setup process.
Make sure your fax machine is connected
to the IF-200. Press any key to continue the
setup process.
If you have not already completed the
Worksheet in the appendix of this guide,
press YES to print out a Worksheet.
If the Worksheet is completed, press NO
and go to section 3.3, “Entering your ISP
and Mailbox Information”.
If you pressed YES above, you see the
screen shown to the left. Press YES if the
Worksheet printed.* Press NO to try again.
*Using this blank Worksheet or the sample Worksheet in the back of this guide, ask your
local LAN or IT administrator to provide the information requested. It will be required in
the next section of this Guide to attach the IF-200 to the LAN.
WELCOME to the world
of IP Fax Mail!
vX.XX
<Press any key>
Connect FAX machine
to FAX port on the
IF-200
<Press any key>
Print IF-200
worksheet detailing
required ISP info?
YES NO
Did worksheet
print OK?
Y
ES NO