Filter
Top Products
5. Reference
29
5-4. Setting Range of Frequency
Depending upon your operating environment, it may be necessary to set the frequency that corresponds
to your graphics board. If you install it for the first time or change environment, set the monitor.
NOTE
• Refer to the manual of the graphics board.
•These environment described below can be set regardless of whether or not the computer is running.
How to set
1
Press to turn off the unit.
2
Press again while pressing .
3
Select the input signal using the in the <Signal Selection> menu at the
center of the monitor.
Use to select (or just confirm) the frequency that corresponds to your
graphics board, and then press
.
[Analog Input]
Setting Horizontal scanning frequency
(kHz)
Vertical scanning frequency
(Hz)
Normal 24~94 47~86
Wide 24~130 47~120
[Digital Input (DVI/DisplayPort)]
Setting Horizontal scanning frequency
(kHz)
Vertical scanning frequency
(Hz)
Normal 31~76 59~61
Wide 26~78 23~63
4
Restart the computer if the settings have been changed.