Filter
Top Products
Chapter 6 Performing Sweep Measurements
© National Instruments Corporation 6-3 Getting Started with LabVIEW SignalExpress
Figure 6-2. Sweep Step Setup Dialog Box
You used the Sweep step to specify a range of values to iterate through
the Frequency parameter of the Create Signal step. The Create Signal
step uses the defined frequency range to generate a sine wave at each
of these frequencies. However, you can use the Sweep step to sweep
any sweepable parameter value of any sweepable step in a project.
9. Click the Sweep Output tab.
10. Click the Add button to display the list of sweep outputs from each
step in the project.
11. Select the response amplitude in dB output under Formula and click
the OK button to plot this measurement against the swept Frequency
parameter.
The Sweep step creates a loop around all the steps in the Project View
to include all the steps in the sweep operation.